Sea-Bird Electronics SBE 38 Manual de usuario descargar pdf (Pagina 83)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

5. In the Start Real-Time Data Acquisition dialog box, click Start.

A. If you selected Begin archiving data immediately or Begin archiving

data when ‘Start Archiving’ command is sent above, and selected

Prompt for Header Information in the Header Form setup (Configure

Outputs), the Header Information dialog box appears. Fill in the

desired header and click OK.

B. If you selected NMEA position data added in the .xmlcon or .con file,

Seasave initializes NMEA communications.

C. If you selected Check Scan Length in the Options menu, Seasave

checks the .xmlcon or .con file to verify that the scan length defined by

the configuration file matches the 19plus V2 (i.e., number of sensors

and inclusion of NMEA is as defined in the file). If a Scan length error

appears, verify that:

• You are using the correct .xmlcon or .con configuration file.

• The configuration file has been updated as necessary if you added

or deleted sensors, added or deleted NMEA or Surface PAR, etc.

D. Seasave sends a message: Waiting for data. . . If you have already

started logging data, ignore the message; otherwise, slide the

magnetic switch to the On position or apply external power, as

applicable to your setup of the 19plus V2. Seasave times out if data is

not received within Timeout in seconds at startup.

E. Real-time data then starts appearing in the screen displays.

6. To stop real-time data acquisition: In the Real-Time Data menu,

select Stop.

7. Stop logging:

• If IgnoreSwitch=N and AutoRun=N: Put the magnetic switch in the

Off position.

• If IgnoreSwitch=Y and AutoRun=N: Close Seasave, then open

Seaterm232 and send Stop.

• If AutoRun=Y: Remove external power.

Notes:

• If in Moored mode, the 19plus V2

must be sampling autonomously to

use Seasave for real-time data

acquisition. Start sampling by

sending StartNow or StartLater in

Seaterm232 before starting

acquisition in Seasave.

• To prevent problems in the use of

the COM port, click Disconnect in

the Communications menu in

Seaterm232, and close Seaterm232

before starting real-time acquisition

in Seasave.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 123 124

Comentarios a estos manuales

Sin comentarios

Sea-Bird Electronics SBE 38 Manual de usuario Pagina 83

Comentarios a estos manuales