Sea-Bird Electronics SBE 38 Manual de usuario descargar pdf (Pagina 55)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

Output Format Setup Commands

See Data Output Formats after the command descriptions for complete details

on all the formats.

OutputFormat=x x=0: Output raw frequencies and voltages

in hexadecimal. Must use this format for

acquiring and viewing real-time data in

Seasave. When using Seaterm232’s

Upload menu, Seaterm232 always uploads

data from memory in raw hex (compatible

with SBE Data Processing), regardless of

user-programmed OutputFormat=.

x=1: Output converted (engineering units)

data in hexadecimal.

x=2: Output raw frequencies and voltages

in decimal.

x=3: Output converted (engineering units)

data in decimal.

x=4: Output pressure and scan number

only, in hexadecimal. Typically used only

for interfacing with Auto Fire Module

(AFM) and SBE 32 Carousel Water

Sampler or with SBE 55 ECO Water

Sampler (for autonomous water sampling).

x=5: Output converted (engineering units)

data in decimal, in XML.

OutputSal=x x=Y: Calculate and output salinity (psu).

Only applies if OutputFormat=3 or 5.

x=N: Do not.

OutputSV=x x=Y: Calculate and output sound velocity

(m/sec), using Chen and Millero formula

(UNESCO Technical Papers in Marine

Science #44). Only applies if

OutputFormat=3 or 5.

x=N: Do not.

OutputUCSD=x x=Y: Calculate and output density sigma-t

(kg/m

), battery voltage, and operating

current (mA) with data polled while

logging. Voltage and current measured

after delay before sampling, but before

sampling. Operating current measured and

output only if in Moored mode. Only

applies if OutputFormat=3 or 5.

x=N: Do not.

Note:

Output format does not affect how

data is stored in FLASH memory.

Sea-Bird’s real-time data acquisition

(Seasave) and data processing

(SBE Data Processing) software

require data in raw hexadecimal

(OutputFormat=0).

Typical use of the output format

command is:

• Before beginning logging:

 If you will use Seasave to view

real-time data - Set output format

to raw hex.

 If you will use Seaterm232 to

view real-time data - Set output

format to converted decimal for

ease in viewing real-time data.

• After stopping sampling, use

Seaterm232’s Upload menu to

upload data from memory. This

automatically uploads the data in

raw hex (regardless of the

OutputFormat= setting), so the

uploaded data is compatible with

SBE Data Processing for processing

and with Seasave for viewing

archived data.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 123 124

Comentarios a estos manuales

Sin comentarios

Sea-Bird Electronics SBE 38 Manual de usuario Pagina 55

Comentarios a estos manuales