Sea-Bird Electronics SBE 38 Manual de usuario descargar pdf (Pagina 23)

Manual revision 006 Section 2: Description of SBE 19plus V2 SBE 19plus V2

Horizontal Mount

Shown below is the horizontal mount plumbing arrangement of a 19plus V2

configured with the optional SBE 5T titanium or 5P plastic pump, and SBE 43

dissolved oxygen (DO) sensor. Note that the SBE 43 is plumbed into the

system between the conductivity cell outlet and the pump inlet.

• Place the DO sensor intake above the conductivity sensor exhaust.

• Place the pump intake above the DO sensor exhaust.

• Orient the pump with the exhaust outlet corner up.

• If the system does not include a DO sensor, connect the tubing from the

conductivity cell directly to the pump intake.

• Main plumbing is 13 mm ID x 19 mm OD

(1/2 inch x 3/4 inch) Tygon tubing.

• A 13 mm (1/2 inch) long piece of

9.5 mm ID x 13 mm OD (3/8 inch x

1/2 inch) Tygon tubing to provide tight

seals to main plumbing is installed:

- on SBE 43 intake and exhaust, and

- on conductivity cell exhaust when

optional anti-foul fittings are installed on

19plus V2.

DO sensor intake and

exhaust tubing detail

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 123 124

Sin comentarios

Sea-Bird Electronics SBE 38 Manual de usuario Pagina 23