Sea-Bird Electronics SBE 38 Manual de usuario descargar pdf (Pagina 38)

Section 4: Setting Up MicroTSG SBE 45

Polled Sampling Commands

These commands are used by an external controller to request a sample from

the MicroTSG. The MicroTSG stores data for the most recent sample in its

RAM. The MicroTSG does not automatically go to sleep after executing

these commands. Do not send these commands if the MicroTSG is sampling

data at pre-programmed intervals (defined by Interval= and SingleSample=).

TS Take sample, hold converted data in RAM,

output converted data.

TSR Take sample, hold raw data (temperature and

conductivity only) in RAM, output raw data.

SLT Send last sample from RAM, output converted

data, then take new sample and hold converted

data in RAM.

TH Take sample, hold converted data in RAM.

SH Send held converted data from RAM.

Testing Commands

TT Measure temperature 100 times or until Esc

key is pressed, output converted data.

TC Measure conductivity 100 times or until Esc

key is pressed, output converted data.

TTR Measure temperature 100 times or until Esc

key is pressed, output raw data.

TCR Measure conductivity 100 times or until Esc

key is pressed, output raw data.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 103 104

Sin comentarios

Sea-Bird Electronics SBE 38 Manual de usuario Pagina 38