Sea-Bird Electronics SBE 38 Manual de usuario Pagina 27
- Pagina / 104
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Section 3: Installing System SBE 45
19
Installing MicroTSG
1. New MicroTSGs are shipped with an AF24173 Anti-Foulant Device pre-
installed. Verify that the Anti-Foulant Device is in the anti-foulant device
cup (see Section 6: Routine Maintenance and Calibration for access to
and replacement of the Anti-Foulant Device).
2. Mount the MicroTSG, with the electrical connector at the top, using the
four
1
/4-inch bolt holes on the sides. Provide clearance as follows:
• Bottom — 152 mm (6 inches) clearance for removal of the
bottom plate, to allow access for replacing the AF24173 Anti-Foulant
Device and cleaning.
• Top — 305 mm (12 inches) clearance for removal of the top plate, to
allow access for removing sensors and electronics.
• Sides — small clearance by using washers with the mounting
hardware, to prevent binding when removing the top or bottom plate.
3. Install the I/O cable:
A. Lightly lubricate the sides of the rubber prongs on the cable connector
with silicone grease (DC-4 or equivalent).
B. Install the cable connector, aligning the long pin with the small hole
on the MicroTSG’s bulkhead connector.
C. Place the locking sleeve over the connector. Tighten the sleeve finger
tight only. Do not overtighten the locking sleeve and do not use a
wrench or pliers.
4. Install the piping connections to the MicroTSG. The housing is tapped
with
3
/8-inch U.S. standard NPT threads. Nylon hose barb fittings for
3
/8-inch tubing are provided.
5. Verify that the hardware and external fittings are secure.
6. For use without optional Interface Box: Connect the MicroTSG to the
computer and power supply.
• Connect the I/O cable connector to your computer’s serial port.
• Connect the I/O cable connector’s red (+) and black (-) wires to a
power supply (8-30 VDC).
Ground pin: Computer data common (pin 1)
Receive pin: RS-232C receive data transmitted from computer (pin 2)
Transmit pin: RS-232C transmit from MicroTSG to computer (pin 3)
Power pin: 8-30 VDC (pin 4)
7. For use with optional Interface Box: See schematic in System Schematic
and Installation Guidelines above, and see PN 90402 – SBE 45 Power,
Navigation, and Remote Temperature Interface Box manual.
I/O
cable
connector
Locking
sleeve
CAUTION:
Do not use WD-40 or other
petroleum-based lubricants, as they
will damage the connector.
Orientation Pin
Ground Pin 1
Transmit Pin 3 Power Pin 4
Receive Pin 2
Bolt hole
(typical)
Top plate
Bottom plate
Electrical
connector
24
- SBE 45 MicroTSG 1
- THERMOSALINOGRAPH 1
- TABLE OF CONTENTS 3
- SBE45 MicroTSG 8
- (Thermosalinograph) 8
- Limited Liability Statement 10
- Table of Contents 11
- Table of Contents SBE 45 12
- Section 1: Introduction 13
- Unpacking MicroTSG 14
- System Description 15
- Specifications 17
- Dimensions and Connector 18
- Sample Timing 19
- Power and Cable Length 21
- Section 3: Installing System 23
- MicroTSG data stream 25
- Power-Up Jumper Check 26
- Installing MicroTSG 27
- See SEATERM’s Help files 28
- Status bar 29
- Command/Data Echo Area 29
- Toolbar 29
- Sampling Modes 32
- Autonomous Sampling 33
- Timeout Description 34
- Command Descriptions 35
- Data Output Format 40
- Section 5: Operating System 42
- Processing Data 44
- Corrosion Precautions 45
- Cleaning and Storage 45
- Sensor Calibration 48
- Section 7: Troubleshooting 49
- Glossary 50
- Sensors 51
- Sensor Interface 51
- Appendix II: 52
- AF24173 Anti-Foulant Device 56
- Index SBE 45 61
- Deployment 62
- MicroTSG (Thermosalinograph) 64
- CALIBRATION SHEETS 66
- 24-Aug-11 -0.00 67
- 24-Aug-11 1.0000000 68
- APPLICATION NOTES 69
- General Discussion 70
- Active Use (after each cast) 71
- Cleaning Materials 72
- For 100 cc of solution: 73
- (recommended) 77
- Temperature Sensors 84
- ITS-90 TEMPERATURE SCALE 88
- APPLICATION NOTE NO. 71 90
- Revised March 2008 90
- 92
- DRAWINGS 96
- WARRANTY POLICY 2010 100
- SOFTWARE WARRANTY 102
- PAYMENT/BILLING INFORMATION 104
Relacionado con productos y manuales para De medición, control y control Sea-Bird Electronics SBE 38
(124 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.114 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales