Sea-Bird Electronics SBE 38 Manual de usuario descargar pdf (Pagina 35)

Section 4: Setting Up MicroTSG SBE 45

Command Descriptions

This section describes commands and provides sample outputs.

See Appendix III: Command Summary for a summarized command list.

When entering commands:

• Input commands to the MicroTSG in upper or lower case letters and

• The MicroTSG sends ? CMD if an invalid command is entered.

• If the system does not return an S> prompt after executing a command,

press the Enter key to get the S> prompt.

• If in quiescent state, re-establish communications by clicking Connect on

the Toolbar or pressing the Enter key to get an S> prompt.

Status Command

DS Display operating status and setup parameters.

Equivalent to Status on Toolbar.

List below includes, where applicable,

command used to modify parameter.

• Firmware version and serial number

• Logging status -

logging data, not

logging data,

or unknown status

• Sample interval time [Interval=]

• Output conductivity with each sample

[OutputCond=]?

• Output salinity with each sample

[OutputSal=]?

• Output sound velocity with each sample

[OutputSV=]? If yes, sound velocity

algorithm [SVAlgorithm=].

• Start sampling automatically when power on

[AutoRun=]?

• Go to sleep after taking single sample

[SingleSample=]?

• Go to sleep after 2 minutes of inactivity

[AutoOff=]?

• A/D cycles to average per sample

[NCycles=]

• Output format (does not appear if

OutputFormat=0. Shows conductivity

leading space is suppressed if

OutputFormat=1; shows conductivity and

salinity order reversed if OutputFormat=2)

Example: (user input in bold)

S>DS

SBE45 V 1.1b SERIAL NO. 1258

not logging data

sample interval = 10 seconds [Interval=]

output conductivity with each sample [OutputCond=]

do not output salinity with each sample [OutputSal=]

do not output sound velocity with each sample [OutputSV= and SVAlgorithm=]

do not start sampling when power on [AutoRun=]

do not power off after taking a single sample [SingleSample=]

do not power off after two minutes of inactivity [AutoOff=]

A/D cycles to average = 4 [NCycles=]

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 103 104

Comentarios a estos manuales

Sin comentarios

Sea-Bird Electronics SBE 38 Manual de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Sea-Bird Electronics SBE 38