Sea-Bird Electronics SBE 38 Manual de usuario descargar pdf (Pagina 30)

Section 4: Setting Up MicroTSG SBE 45

Following are the Toolbar buttons applicable to the MicroTSG:

Toolbar

Buttons

Description

Equivalent

Command*

Connect

Re-establish communications with MicroTSG.

Computer responds with S> prompt.

(press Enter

key)

Status Display instrument status.

Coefficients Display calibration coefficients.

Capture

Capture instrument responses on screen to file.

File has .cap extension. Click Capture again to

turn off capture. Capture status displays in Status

bar. As MicroTSG has no internal memory, you

must capture before sampling begins to save data

for future review and processing.

—

Diagnostics

Perform one or more diagnostic tests on

MicroTSG. Diagnostic test(s) accessed in this

manner are non-destructive – they do not write

over any existing instrument settings.

DS, DC, TS,

and TSR

Disconnect

Free computer COM port used to communicate

with MicroTSG. COM port can then be used by

another program. Note that MicroTSG must be

connected to COM port for data to be obtained.

—

*See Command Descriptions.

3. In the Configure menu, select SBE 45 TSG. The dialog box looks

like this:

Make the selections in the Configuration Options dialog box:

• COMM Port: COM 1 through COM 10, as applicable

• Baud Rate: 4800 (documented on Configuration Sheet in manual)

• Data Bits: 8

• Parity: None

• Mode: RS-232 (Full Duplex)

Click OK to save the settings.

800

Computer COM port, baud rate,

data bits, and parity for

communication between computer

and MicroTSG.

Interface for communication

between computer and

MicroTSG.

Note:

.cap file created by SEATERM is

not compatible with our post-

processing software (SBE Data

Processing). Instead of using

SEATERM’s capture utility, use

Seasave (our real-time data

acquisition software) to create a

.hex file that is compatible with

SBE Data Processing

(see Section 5: Operating System).

Note:

• SEATERM’s baud rate must be the

same as the MicroTSG baud rate

(set with Baud=). Baud is factory-

set to 4800, but can be changed by

the user (see Command

Descriptions).

• When you click OK, SEATERM

saves the Configuration Options

settings to the SeaTerm.ini file in

your Windows directory.

SeaTerm.ini contains the last saved

settings for each instrument. When

you open SEATERM and select the

desired instrument (SBE 37, 45,

etc.) in the Configure menu, the

Configuration Options dialog box

shows the last saved settings for

that instrument.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 103 104

Comentarios a estos manuales

Sin comentarios

Sea-Bird Electronics SBE 38 Manual de usuario Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Sea-Bird Electronics SBE 38